topic Re: MSM710 Firmware in M and MSM Series

MSM710 Firmware

Jaap Hoetmer — Mon, 19 Aug 2013 02:38:44 GMT

Hi there.

I tried to upgrade the firmware of a MSM710 from

V5.3.3.0-01-7357

to version

V5.5.3.0-MR_V5.5.3.0-MSM710 or V5.5.1-B9677_V5.5.1.0-MSM710-B9677

both available from the download section of the My Networking site. However, both firmware upgrades failed and generated the following error:

"Firmware upgrade aborted because the new firmware is not correctly signed. Restarting with previous version."

I verified the Management and Configuration Guide but could not find this error message.

Does anyone have a clue as to what to do to get the firmware installed, or to understand why it doesn't work as intended?

Thanks, regards,

Jaap

P.S. This thread has been moved from Communications, Wireless (Legacy ITRC forum) to MSM Series. - HP Forum Moderator

Re: MSM710 Firmware

Fredrik Lönnman — Fri, 06 Jan 2012 22:10:00 GMT

Never seen that error.. could you double check the m5 hash of the 5.5.1.0 release, in case it was broken during download?

MD5 (V5.5.1.0-MSM710-B9677.cim) = 25beea0b397954dc804f84fade3082a3

You could also try using a 5.4 version as interim, maybe the 5.3 -> 5.5 jump is not supported.

Re: MSM710 Firmware

Jaap Hoetmer — Fri, 06 Jan 2012 22:58:49 GMT

Thanks for the reply, the MD5 hash is correct so it is not due to download issues.

However, I did find the following in the 5.5.3 release notes:

"Only MSM7xx Controllers and MSM Access Points that
are covered by a software Care Pack or software Contract can be upgraded from v5.3.x or 5.4.x to
v5.5.0. Please contact HP Support for entitlement determination and download instructions."

I don't believe this device currently has a valid contract or Care Pack, but the error message doesn't seem to indicate that this is the reason why the upgrade is not performed.

Thanks, regards,

Jaap

Re: MSM710 Firmware

SingleCell — Sun, 19 May 2013 21:28:06 GMT

Hey Jaap,

I have a MSM710 controller and upgraded it to 5.7.1.1 and there it is stuck. Can down or upgrade.

I get this error message everytime.

**Firmware upgrade aborted because the new firmware is not correctly signed. Restarting with previous version.**

Have you solved yours?

Thx

SingleCell