https://community.hpe.com/t5/m-and-msm-series/msm430-set-to-autonomous-mode-then-no-access/m-p/6194055#M2244 <P>I am setting up some MSM430 and choosing autonomous mode.&nbsp; the web interface says it is restarting, and that is where it stays.&nbsp; I cannot connect to the device after that.</P><P>&nbsp;</P><P>The power button is green, and the LAN light flashes.&nbsp;</P><P>&nbsp;</P><P>I have the config guide and it says to go to 192.168.1.1 for the admin tool.&nbsp; but no access.</P> Wed, 04 Sep 2013 19:11:59 GMT pspecht 2013-09-04T19:11:59Z https://community.hpe.com/t5/m-and-msm-series/msm430-set-to-autonomous-mode-then-no-access/m-p/6194055#M2244 <P>I am setting up some MSM430 and choosing autonomous mode.&nbsp; the web interface says it is restarting, and that is where it stays.&nbsp; I cannot connect to the device after that.</P><P>&nbsp;</P><P>The power button is green, and the LAN light flashes.&nbsp;</P><P>&nbsp;</P><P>I have the config guide and it says to go to 192.168.1.1 for the admin tool.&nbsp; but no access.</P> Wed, 04 Sep 2013 19:11:59 GMT https://community.hpe.com/t5/m-and-msm-series/msm430-set-to-autonomous-mode-then-no-access/m-p/6194055#M2244 pspecht 2013-09-04T19:11:59Z https://community.hpe.com/t5/m-and-msm-series/msm430-set-to-autonomous-mode-then-no-access/m-p/6194105#M2245 <P>Okay.&nbsp; found that the AP was using Ip of 192.168.0.X.&nbsp; ?????</P><P>&nbsp;</P><P>&nbsp;</P> Wed, 04 Sep 2013 20:20:10 GMT https://community.hpe.com/t5/m-and-msm-series/msm430-set-to-autonomous-mode-then-no-access/m-p/6194105#M2245 pspecht 2013-09-04T20:20:10Z