topic Re: MSM710 Config issue in M and MSM Series

MSM710 Config issue

Jforrests — Mon, 02 Dec 2013 05:17:30 GMT

Standard disclaimer about being a little green when it comes to Wireless:
We've just installed 8 HP MSM410 Access points connected to a MSM710 Access Controller. I've joined the AP's to a group and attached that Group to the VSC. I can connect to the AP's and even get an IP from a Windows DHCP Server, however I can't access any network resources through the wireless after that. No Internet, network shares, can't even ping the DHCP server. I THINK I have it configured to use AD for authentication, but could be wrong. I'm sure I'm missing something easy, Any Ideas?

P.S. This thread has been moved from Communications, Wireless (Legacy ITRC forum) to MSM Series. -HP Forum Moderator

Re: MSM710 Config issue

Trevor Commulynx — Sat, 13 Feb 2010 08:23:40 GMT

Post your config.

Re: MSM710 Config issue

Jforrests — Sat, 13 Feb 2010 17:07:41 GMT

Config attached.

I've also hooked a laptop directly to the LAN port configured with a static IP and still can't get out through the Internet Port. I'm wondering if i have that conencted wrong. Its set to pick up an IP through DHCP, and it does. Its connected to my backbone switch from which everything else gains access to the network.

Thanks for taking a look

Re: MSM710 Config issue

Shadow13 — Sun, 14 Feb 2010 06:16:36 GMT

there is an option in the VSC "wireless filter traffic" kindly uncheck it and see

Regards.

Re: MSM710 Config issue

Jforrests — Sun, 14 Feb 2010 15:03:30 GMT

That's got it! Thanks a ton that's been kicking my butt for a week now.

Re: MSM710 Config issue

Shadow13 — Sun, 14 Feb 2010 16:26:40 GMT

you are welcome, actually this option is a security feature that restricts all the traffic for the vsc to the controller only, if you have guest VSC and are using internet port to give them access to only the internet then you should use that, other wise don't use it.

Regards ;)

Re: MSM710 Config issue

Jforrests — Sun, 14 Feb 2010 16:30:54 GMT

Ahh, good to know. I will be setting up an Guest VSC for Internet access only.

Thanks Again!