https://community.hpe.com/t5/m-and-msm-series/msm760-guest-web-authentication-on-multiple-subnets/m-p/4692415#M3343 You need to check the checkbox that says "always tunnel client traffic to the controller", this will do exactly as it is advertised, which is to tunnel the traffic all the way through the network to the controller ensuring the ALL guest traffic will reach the controller. Wed, 06 Oct 2010 12:45:40 GMT Fred! 2010-10-06T12:45:40Z https://community.hpe.com/t5/m-and-msm-series/msm760-guest-web-authentication-on-multiple-subnets/m-p/4692414#M3342 <P>Hello, I am trying to figure out how to span a VSC using web authentication over multiple subnets. I have a controller located at one site servicing APs at 3 sites with multiple VSCs but only the site with the controller can use the web authentication page. I know the LAN interface must be used as the default gateway, but I am not sure how to make this work on a subnet not directly attached to the controller.</P> <P>&nbsp;</P> <P>P.S. This thread has been moved from Communications, Wireless (Legacy ITRC forum) to MSM Series. -HP Forum Moderator</P> Mon, 02 Dec 2013 08:33:53 GMT https://community.hpe.com/t5/m-and-msm-series/msm760-guest-web-authentication-on-multiple-subnets/m-p/4692414#M3342 Rob Kusbel 2013-12-02T08:33:53Z https://community.hpe.com/t5/m-and-msm-series/msm760-guest-web-authentication-on-multiple-subnets/m-p/4692415#M3343 You need to check the checkbox that says "always tunnel client traffic to the controller", this will do exactly as it is advertised, which is to tunnel the traffic all the way through the network to the controller ensuring the ALL guest traffic will reach the controller. Wed, 06 Oct 2010 12:45:40 GMT https://community.hpe.com/t5/m-and-msm-series/msm760-guest-web-authentication-on-multiple-subnets/m-p/4692415#M3343 Fred! 2010-10-06T12:45:40Z