HPE Community
HPE 3PAR StoreServ Storage
1753696 Members
5409 Online
108799 Solutions
New Discussion

3PAR 8200 FCOE configuration with Vpshere 6

 
shang1983
Advisor

‎10-26-2016 09:04 PM

‎10-26-2016 09:04 PM

3PAR 8200 FCOE configuration with Vpshere 6

Hello,

I've a new 3PAR 8200 comes with two port 10GB FCOE/iSCSI adapter on both nodes. I've only experience configured 3PAR with FC connection only. This is my first time configure 3PAR with FCOE. 

Could anyone guide me on how to configure the port of the FCOE. I don't see a tab with FCOE on port type in the 3par management console.  Or Do i use the port type iSCSI?

On the Vsphere host side, I configure adapter binding with software iSCSI adapter.

 

 

0 Kudos
Reply
1 REPLY 1
yapkl
Trusted Contributor

‎10-26-2016 11:00 PM

‎10-26-2016 11:00 PM

Re: 3PAR 8200 FCOE configuration with Vpshere 6

Have you tried this HPE 3PAR VMware ESX/ESXi Implementation Guide?

http://h20565.www2.hpe.com/hpsc/doc/public/display?docId=c03290624

Best Regards,

yapkl

Note: The opinions & comments above are my personal opinions, not of Hewlett Packard Enterprise
----------
If my post was useful, click on my KUDOS! thumb below! Thanks.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.