HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
3PAR StoreServ Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

3PAR doesn't see ESX 4 WWNs

 
MarkoZ
Occasional Contributor

3PAR doesn't see ESX 4 WWNs

Hello,

 

we have a strange problem with one 3PAR implementation. 3PAR doesn't see ESX 4 host WWNs so we can't add ESX 4 hosts and present LUNs. It is strange because in the same deployment 3PAR sees Hyper-V 3.0 hosts without any problems and we can present LUNs to Hyper-V servers.

 

On SAN switch we can SEE WWNs on all ports (ESX hosts, 3PAR ports, Hyper-V hosts, old EVA ports).

 

We are sure zoning is configured correctly.

 

Any idea what could be wrong?

 

Thank you!

 

Best wishes,

Marko

 

 

P.S. This thread has been moevd from Storage > General to Storage Area Networks (SAN) (Enterprise). - Hp forum Moderator

1 REPLY
Jason_L
Valued Contributor

Re: 3PAR doesn't see ESX 4 WWNs

I assume you are creating the host definition and trying to choose the host from a list of available WWN's?

 

What is the 3par model and Inform level?

 

Also, information from the hosts, HBA type, HBA driver, HA firmware....etc.

 

Switch type, model and FOS/NOS.

 

If zoning and physical connectivty is confirmed, then next step is  to check that we are dealing with a configuration that meets interoperability requirements.

I work for HPE.