cancel
Showing results for 
Search instead for 
Did you mean: 

3PAR node image

 
pureslash
Occasional Visitor

3PAR node image

Does anyone know if there is a way to "reimage" the node SSD? .. long story.. but.. i lost both nodes in a power glitch.. HPE replaced the nodes.. and.... when repaired, they put in the wrong serial number... didn't realize for a couple of months, as I had other projects going on and this wasn't in production...

So, how do I COMPLETELY start over and input the original serial number? I hear there may be something called "bitb" - back in the box? .. or.. just the same - if i pop out the SSD in the nodes and reimage them..?

Thoughts?

4 REPLIES
yapkl
Trusted Contributor

Re: 3PAR node image

Hi pureslash,

Welcome to the community!
My suggestion is call HPE support and ask them to fix it.
Best Regards,

yapkl

Note: The opinions & comments above are my personal opinions, not of Hewlett Packard Enterprise
----------
If my post was useful, click on my KUDOS! thumb below! Thanks.
pureslash
Occasional Visitor

Re: 3PAR node image

Already done that... I've been sittiing here with HPE tech due for the past 5 hours... was looking for suggestions from the community...

yapkl
Trusted Contributor

Re: 3PAR node image

Well, this is not something you want to mess about yourself with community suggestions. Work with HPE support.
Best Regards,

yapkl

Note: The opinions & comments above are my personal opinions, not of Hewlett Packard Enterprise
----------
If my post was useful, click on my KUDOS! thumb below! Thanks.

Re: 3PAR node image

startnoderescue will copy the image from one node to another.  I don't know about the serial #.