3PAR StoreServ Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

3Par v400. How do you remove manually added host WWNs?

 
SOLVED
Go to solution
figwiggleman
Occasional Contributor

3Par v400. How do you remove manually added host WWNs?

I manually added some WWNs for an HPUX host1 because they would not appear in the Available WWNs list in IMC. I then discovered a zoning issue and was able to get a second HPUX host2 WWNs to appear in the IMC without manually adding them. Then I removed host1 WWNs from the SAN switch zone config, yet they still appear in the IMC. How can I remove them?

 

Thanks,

Tim

 

2 REPLIES
Sheldon Smith
Honored Contributor
Solution

Re: 3Par v400. How do you remove manually added host WWNs?

See the CLI. Try

controlport nssync [–f] <N:S:P>...


Note: While I work for Hewlett Packard Enterprise, all of my comments (whether noted or not), are my own and are not any official representation of the company.
----------
If my post was useful, click on my KUDOS! thumb below!
figwiggleman
Occasional Contributor

Re: 3Par v400. How do you remove manually added host WWNs?

Well I had already gotten this answer from our support engineer this morning, but yes that command did it. I ran it on each front end port showing the "Ghost WWNs". Thank you Sheldon.