3PAR StoreServ Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

3paradm login and password

 
julmisgo
Occasional Advisor

3paradm login and password

hI everybody, 

today i've configured a 3par 8200+ 1 disk enclosure in CLI, during all the installation, i've never been requested to set or change 3paradm user login and password, but just choose between : 

At this point it must be specified whether this system should be configured to use
Time-based One-Time Passwords (totp) or Ciphertext (cipher) for the root and console users.


totp or cipher? and i chose cipher, 

at the end of the CLI configuration, i'm not able to add my 3par storeserv to the SP, and also cannot login to 3par Management Console. 

have somebody faced this?

3 REPLIES
Sheldon Smith
Honored Contributor

Re: 3paradm login and password

The Root and Console user IDs are for systems hardware maintenance. You would be using the super-role user "3paradm" for (initial) operations of the system. The default password is "3pardata" which you should change at your convenience. You can also make your own super-role username.

Connect to the system's management IP address using the 3PAR StoreServ Management Console (browser-based GUI) or via command line using "ssh" (if connecting from Windows, typically PuTTY).


Note: While I work for Hewlett Packard Enterprise, all of my comments (whether noted or not), are my own and are not any official representation of the company.
----------
If my post was useful, click on my KUDOS! thumb below!
julmisgo
Occasional Advisor

Re: 3paradm login and password

woooow!!! completely forgoet :-( 

thank you a lot!!

for now i can connect to system only using ssh. 

Sheldon Smith
Honored Contributor

Re: 3paradm login and password

If you can connect to the system via command line with ssh, then you should be able to install and use the HPE 3PAR StoreServ Management Console (SSMC) as well.

For SSMC, you need a 64-bit server prepared, running one of the following:

  • Windows Server 2008 R2, 2012, 2012 R2, 2016 (all editions)
  • Windows 7, 8.1, 10 (all editions except Windows RT)
  • Red Hat Enterprise Linux 6.5, 6.6, 6.7, 7.0, 7.1, 7.2,7.3

The server can be either physical or virtual. Two CPUs are the minimum. The server will need TCP/IP connectivity to the HPE 3PAR StoreServ controller nodes using TCP ports 5782 and 5783. For storage administrators to access SSMC from a LAN-attached system via browser, the default is TCP port 8443.

The latest version of SSMC (3.2 at the time of this writing) is available at https://h20392.www2.hpe.com/portal/swdepot/try.do?productNumber=SSMC_CONSOLE – You will need a free HP Passport to sign in.


Note: While I work for Hewlett Packard Enterprise, all of my comments (whether noted or not), are my own and are not any official representation of the company.
----------
If my post was useful, click on my KUDOS! thumb below!