HP 3PAR 7400 2 Nodes

[otmani]

my node 0 crash  .i  change it  but it don't want to join cluster.

i check ld  and i see that the ld  log0.0   see below

checkld -n log0.0
Performing a kernel level consistency check, will not try to fix inconsistencies
Error: ld log0.0 has invalid state 3

i tried to repair but error 

checkld -y -progress log0.0
Performing a kernel level consistency check, will try to fix inconsistencies
Error: ld log0.0 has invalid state 3

Errors found

how can recreate this logical disk  by admithw ?

thank for answers

regards

[Torsten.]

>> .i  change it 

What exactly did you change?

[otmani]

yes  i change the node 0  . i make startnoderescue  -node 0  is success.

but node 0 not joint node 1 in cluster.  

perhaps restart the storage.

fy

[Torsten.]

noderescue is running as a task.

Do you still have the output of "showtask -d ..." of this task?

I would recommend to ask HPE support before doing anything else.

[otmani]

yes  the  process  noderescue is running .

it is the reason of my Pb . i  can kill this process

[Torsten.]

What does "showtask -d ..." show?

Whenever I do a noderescue, I connect a serial terminal to the node in question and capture the output.

This gives you a lot more information what happens.

[otmani]

i have a capture  of reboot node  0 on console  MGT.

i found  that at the end of boot  node 

init: Loading tpd kernel module: done.
init: Setting up EOS interrupts
init: Configuring powerfail device /dev/pfail_storage: 801
init: done.
init: Initializing eanet0: done.
init: Rotating PM logs: done.
init: Rotating PR event logs: done.
init: Starting Process Manager: pm.
init: Rotating pr_sync_ide logs: done.
init: Starting PR Sync IDE: pr_sync_ide.
init: Starting libvirt management daemon: libvirtd2017-05-23 18:59:49.571+0000: 7622: info : libvirt version: 0.9.12
init: 2017-05-23 18:59:49.571+0000: 7622: warning : virGetHostname:2108 : getaddrinfo failed for 'SN HP 3PAR': Name or service not known
init: .
init: rsync daemon not enabled in /etc/default/rsync, not starting... ... (warning).
init: Starting periodic command scheduler: cron.
init: Running local boot scripts (/etc/rc.local).

[Torsten.]

This looks normal, after your last line there should appear the login prompt.

If 'SN HP 3PAR' is matching your system, the node should be able to join.

[otmani]

yes SN HP 3PAR is my  serial number

yes  i prompt login but when  verfiy by checkhealth   i found only one node  .

and status is  degraded . but node  0 not join node 1  is very strange.