3PAR StoreServ Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

HPE 3PAR 8400 StoreSERV: Unable to edit IP address of Storage System in Administrator Console

 
Highlighted
francis77
Occasional Contributor

HPE 3PAR 8400 StoreSERV: Unable to edit IP address of Storage System in Administrator Console

Hi,

I have recently changed the IP address of one of the StoreServ HPE 8400 storage systems using the CLI however in the management console the change does not show and I have lost this system's associated details. 

Also am unable to edit the IP address associated with the DNS name that was registered. The status shows "Not connected" in Administrator Console with the old IP address and when trying to edit this, it always trie to connect to the old IP address. Please advise if there is a way to edit the IP.

Thanks,

Francis

6 REPLIES 6
Highlighted
giladzzz
Honored Contributor

Re: HPE 3PAR 8400 StoreSERV: Unable to edit IP address of Storage System in Administrator Console

hi

to change Ip address in cli

setnet startaddr oldip newip newnetmask

setnet startgateway newgateway   (if needed)

setnet finish -f   ( this a must to do the change)

if it is not done try pinging the new address to test

or connect with serial console to see address

shownet   (to see if activeted)

Regards

 

Highlighted
francis77
Occasional Contributor

Re: HPE 3PAR 8400 StoreSERV: Unable to edit IP address of Storage System in Administrator Console

Hi,

 

I have done the below tasks and confirmed the new IP address is there using the shownet command. 

I just want to know how do I change it in the Administrator Console as shown in the attached picture because it is still showing the old IP address and I cannot change it using the edit option as its not connected. 

Thanks,

FrancisCapture.PNG

Highlighted
veeyarvi
HPE Pro

Re: HPE 3PAR 8400 StoreSERV: Unable to edit IP address of Storage System in Administrator Console

Hello francis77,

Did you try removing the array from the console and re-adding the same? That should solve this problem.


I am an HPE Employee
Accept or Kudo
Highlighted
giladzzz
Honored Contributor

Re: HPE 3PAR 8400 StoreSERV: Unable to edit IP address of Storage System in Administrator Console

Hi

the best way is to remove it and add it again with the new ip 

don't forget to confirme the certificate

Regards

 

Highlighted
francis77
Occasional Contributor

Re: HPE 3PAR 8400 StoreSERV: Unable to edit IP address of Storage System in Administrator Console

Thanks Veeyarvi and Giladzzz. I will try this tonight.

Regards,

 

Francis

Highlighted
francis77
Occasional Contributor

Re: HPE 3PAR 8400 StoreSERV: Unable to edit IP address of Storage System in Administrator Console

The IP address shows to be connected when adding but the hostname is not showing, when I add by hostname the connection fails