3PAR StoreServ Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

HPE 3PAR and Switch H3C

 
SOLVED
Go to solution
Dimitri_S
Occasional Visitor

HPE 3PAR and Switch H3C

Hi,

I'm connected to HPE 3PAR 8200 to an H3C switch through the 10GB SFP connections to present volumes to two DL360 servers.

H3C Comware Platform Software
Comware Software, Version 5.20, Release 1238P08
Copyright (c) 2004-2010 Hangzhou H3C Tech. Co., Ltd. All rights reserved.
H3C S9508E-V uptime is 68 weeks, 4 days, 21 hours, 6 minutes


But it is not doing it, we configure the ports and physically it is observed that there is connection but when looking for the 3PAR there is no connection. When you ping from the switch to 3PAR, the result is negative:

1. The state of the fibers was checked. They are fine.
2. The servers are directly connected to the 3PAR: It works correctly.
3. The comparison was made with another storage system in question of configuration and have the same configuration for the interfaces for the nodes:

#
interface Ten-GigabitEthernet2/0/11
port access vlan 400
jumboframe enable 9216
#

Thank you very much for the help

3 REPLIES 3
veeyarvi
HPE Pro

Re: HPE 3PAR and Switch H3C

Hello Dimitri_S,

It appears there is  a compatibility issue or configuration mismatch. 

Did this setup ever work?

Also could you disable jumbo frames and try?




Accept or Kudo

Re: HPE 3PAR and Switch H3C

Dimitri_S, which ports on the 3PAR are you using? You did get the add-on iSCSI cards for the 3PAR, correct? Please run the following commands and post the results:

showport

showport -iscsi


Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo

Dimitri_S
Occasional Visitor
Solution

Re: HPE 3PAR and Switch H3C

Hi, Sheldom

3PAR_SYSTEM cli% showport -iscsi
N:S:P State IPAddr Netmask/PrefixLen Gateway TPGT MTU Rate iSNS_Addr iSNS_Port STGT VLAN
0:2:1 ready 0.0.0.0 0.0.0.0 0.0.0.0 21 1500 10Gbps 0.0.0.0 3205 21 Y
0:2:2 offline 0.0.0.0 0.0.0.0 0.0.0.0 22 1500 n/a 0.0.0.0 3205 22 Y
1:2:1 ready 0.0.0.0 0.0.0.0 0.0.0.0 121 1500 10Gbps 0.0.0.0 3205 121 Y
1:2:2 offline 0.0.0.0 0.0.0.0 0.0.0.0 122 1500 n/a 0.0.0.0 3205 122 Y
----------------------------------------------------------------------------------------------
4

I solved the problem.

It was in the VLAN that apparently had not been accepted by switch and likewise configured the gateway to 3PAR and with the problem was overcome. 

Thanks.