HPE Community
HPE 3PAR StoreServ Storage
1751834 Members
5809 Online
108782 Solutions
New Discussion

Issues Replacing disks on 3PAR System

 
roger_sok
Occasional Visitor

‎02-09-2017 04:58 AM - last edited on ‎02-13-2017 08:14 PM by

‎02-09-2017 04:58 AM - last edited on ‎02-13-2017 08:14 PM by

Issues Replacing disks on 3PAR System

I am having same issue here.

 

HP3PAR-SS1 cli% showpd -i -p -cg 0 -mg 8
Id CagePos State ----Node_WWN---- --MFR-- -----Model------ -Serial- -FW_Rev- Protocol MediaType
4 0:8:0 normal 5000CCA0172E7D40 HITACHI HVIPC0600GBFC15K JZVUKLAM VCX3 FC Magnetic
20 0:8:0? failed 5000CCA01E30E674 HITACHI HVIPC0600GBFC15K J9VVWPKL VCX3 FC Magnetic
------------------------------------------------------------------------------------------------

 

Regards

Roger

0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎02-09-2017 05:07 AM

‎02-09-2017 05:07 AM

Re: Replacing disks on 3PAR System (servicemag)

a common problem of "me too" and "I am having same issue here." - nobody knows what YOUR problem really is, since you have likely other symptoms, other versions,, maybe other devices etc ...

 

Better open an own thread.

 

However, looks like a "dismisspd 20" could solve your problem, if the servicemag has finished and the old disk is still shown.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.