HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
3PAR StoreServ Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

Modify LUN ID when Adding a Volume to Volume Set

 
NTA1201
Occasional Visitor

Modify LUN ID when Adding a Volume to Volume Set

Hello,

 

For ESX machines I created a Host Set and VV Set.

4 systems are in Host Set and 5 volumes in Volume Set.

I would like to add a new volume in VV Set but at the same time, modifying the LUN ID. Is it possible?

 

 

Thx.

NTA.

2 REPLIES

Re: Modify LUN ID when Adding a Volume to Volume Set

Sorry, no. Volume Set LUNs are contiguous. If you want a LUN number other than the next in the Volume Set series, you will have to assign it to your Host Set separately.

 


Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company.
----------
If my post was useful, click on my KUDOS! thumb below!

Re: Modify LUN ID when Adding a Volume to Volume Set

>I would like to add a new volume in VV Set but at the same time, modifying the LUN ID.

 

On 3.2.2 you can expand VV sets and hop over used LUNs.  So unless that desired LUN is close by, you're in for a heap of pain trying to add/remove dummy VLUNs.

 

>VV Set LUNs are contiguous. If you want a LUN number other than the next in the VV Set series

 

Not any more for expansion but it would be difficult to get an exact value.