3PAR StoreServ Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

No chunklets to move? Replaced disk

zzzzzxx1
Contributor

No chunklets to move? Replaced disk

Hello!

 

We recently replaced a failed disk with HP support and after a servicemag resume which auto started, it says it sucessfully brought the mag online, but said no chunkets to move? Is this normal? The output is below...

 

 

servicemag status -d 2 20
The magazine was brought online by a successful servicemag resume command.
The command completed at Wed Feb 21 11:25:47 2018.
The output of the servicemag resume was:
servicemag resume 2 20
... mag 2 20 already onlooped
... firmware is current on pd WWN [5000C500A0D8F8F4]
... firmware is current on pd WWN [5000C50070D323E4] Id [81]
... checking for valid disks...
... checking for valid disks...
... disks in mag : 2 20
... normal disks: WWN [5000C500A0D8F8F4] Id [ 6] diskpos [0]
... not normal disks: WWN [5000C50070D323E4] Id [81]
... playback chunklets from pd WWN [5000C500A0D8F8F4] Id [ 6]
... All chunklets played back / relocated.
... cleared logging mode for cage 2 mag 20
... no chunklets to move
... -pdid(s) 81 successfully dismissed.
servicemag resume 2 20 -- Succeeded

2 REPLIES
Dennis Handly
Acclaimed Contributor

Re: No chunklets to move? Replaced disk

Perhaps you had nothing on that PD?  I assume that 5000C50070D323E4 was the bad disk?

A "showpdch -mov" would show all chunklets that were moved or are to be moved.

amir_sh
Frequent Advisor

Re: No chunklets to move? Replaced disk

hi

 

showpdch -from PDID