3PAR StoreServ Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

Reconfigure InServ and SP network settings

SOLVED
Go to solution
madness
Visitor

Reconfigure InServ and SP network settings

I need to change settings Inserv and SP network, which aspects should  I consider before performing these steps and what would be the procedure?
 
Can anyone help me please?
3 REPLIES
Dennis Handly
Acclaimed Contributor

Re: Reconfigure StoreServ and SP network settings

What version of SP and StoreServ software?

The CLI command setnet is what you can use for the array.

Are you just talking about the network for management?  Or do you have iSCSI and RCIP?

madness
Visitor

Re: Reconfigure StoreServ and SP network settings

- The version of VSP is 4.1.0 and the console managemen is 4.7.1

- I am just talking about the network for management.

shang1983
Advisor
Solution

Re: Reconfigure StoreServ and SP network settings

I've done the Re-IP of SP and 3PAR Management console before. 

You can change service processor IP in the SPOCC. On the left side menu select SPmaint. Then Select "option 2. Network configuration. Then "Select Option 4. Change public IP Network interface parameters". Change the IP needed then "save and activate."

You will need to close the browser and re-open to enter new SP IP.

For 3PAR Management console. I used CLi command to change the Management IP. I refer to this link for guide:

http://h20564.www2.hpe.com/hpsc/doc/public/display?docId=mmr_kc-0115900

Type setnet startaddr "current IP" "new IP" "subnet mask" and enter

It will show the status change of IP successfully started

Type shownet to view the status of changing IP. 

To complete the setting type setnet finish. If you want to force IP change without verifying type setnet finish -f 

Then type shownet again to verify the state.