3PAR StoreServ Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

SPLUNK as syslog 3PAR

RaviSE
Occasional Visitor

SPLUNK as syslog 3PAR

Hej,

 

Is there any way to send test traps from 3PAR after external syslog configuration.

3 REPLIES
Wassim_SV
HPE Pro

Re: SPLUNK as syslog 3PAR

Hello,

You can send a test trap to all SNMP managers displayed with the showsnmpmgr command. Procedure Issue the checksnmp command. The CLI displays the IP addresses of the tested managers.

You have first to To register the SNMP manager with the agent, use the setsnmpmgr command followed by the IP address of the SNMP manager

You can find all details on the document Page 247-252 HPE 3PAR Command Line Interface Administrator Guide :

https://support.hpe.com/hpsc/doc/public/display?docId=c04204251

 

I am an HPE Employee
Haitao_Zhang
HPE Pro

Re: SPLUNK as syslog 3PAR

Hello,

You can use the "checksnmp" command to send an SNMP test trap.

EXAMPLES
cli% checksnmp
Trap sent to the following managers:
192.168.17.10:162
192.168.17.111:1000

3PAR Support Specialist
Anovelli
Occasional Visitor

Re: SPLUNK as syslog 3PAR

Syslog is used to audit purposes, in my case, after setting and enabling syslog via setsys command, messages began to arrive in great amounts that no test message was necessary. you are intended to monitor events? consider use snmp traps.