3PAR StoreServ Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

Service Processor5.0 Port 443

axelle94
Occasional Visitor

Service Processor5.0 Port 443

Hello,

 

should we configure outbound and inbound port 443 with the service processor 5.0 ?

I don't find it in the documentation.

 

3 REPLIES
Preethi_C
HPE Pro

Re: Service Processor5.0 Port 443

Hi,

You need to set the port 8443 to access Service Processor.

For more information, refer to the user guide:

https://support.hpe.com/hpsc/doc/public/display?docId=emr_na-a00006416de_de 

Regards,

Preethi.

I work for HPE!
If you feel this was helpful please click the KUDOS! thumb below!

Emmanuel_S1
HPE Pro

Re: Service Processor5.0 Port 443

Here are some information on the port requirements.

--------------------------------

Requirements for Setting Firewalls and Ports:

Meeting firewall and port requirements are necessary when configuring inbound and outbound connections on HP 3PAR arrays. An inbound connection enables remote access to SP and StoreServ for authorized HP 3PAR support personnel. An outbound connection enables diagnostic data transfer such as alerts, StoreServ, SP log files, and configuration files for remote diagnosis. Secure Network Mode is a mode used for communication between the SP and HP 3PAR Connection portal for diagnostic data transfer (outbound) and Remote Access (inbound).

NOTE: Connectivity to only one of the Global Access Servers is required for remote support.
Network Requirement
Secure Network Mode
3PAR support portal IP address
Your DNS server should allow remote3par.houston.hp.com to be resolved to 15.201.225.95
Outbound connectivity (Secure Service Collector Server)
Port 443 (https) to be opened (outbound) between service processor IP and the following IP address: remote3par.houston.hp.com: 15.201.225.95.
Inbound Connectivity (Global Access Server)
Port 443 (https) to be opened (outbound) between Service Processor IP and the following IP addresses:
 

 

15.201.200.205 g4t2481g.houston.hp.com

  •  

 

15.201.200.206 g4t2482g.houston.hp.com

  •  

 

15.240.0.73 g9t1615g.houston.hp.com

  •  

 

15.240.0.74 g9t1616g.houston.hp.com

  •  
    NOTE: If the StoreServ Storage system or the SP are placed on different IP networks and an IP firewall exists between them, the following ports must be opened for communication between the StoreServ Storage system and the SP:
     

Port 22 (SSH)–Used for depositing and executing programmatically driven service scripts and for collecting an archive of diagnostic data (known as an InSplore).

Port 2540 (CLI)–Used for gathering system health information, configuration data, and performance data. • Port 5781 (Event Monitor)–Used for monitoring system events on the StoreServ Storage system.

Register a Kudo by clicking the thumb if this helped in your issue.
Please consider marking it as an Accepted Solution if issue is resolved.

I am an HPE Employee.
Emmanuel_S1
HPE Pro

Re: Service Processor5.0 Port 443

Correction : For SP 5.0 release you will need to open up 8443 as stated by in previous post.

Register a Kudo by clicking the thumb if this helped in your issue.
Please consider marking it as an Accepted Solution if issue is resolved.

I am an HPE Employee.