- Community Home
- >
- Storage
- >
- Midrange and Enterprise Storage
- >
- HPE 3PAR StoreServ Storage
- >
- Re: Table of contents (TOC) quorum not reached. 3p...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-30-2020 11:07 PM
01-30-2020 11:07 PM
Table of contents (TOC) quorum not reached. 3par7400
hello
im in state after restart 3par7400 3.2.2 mu2
TOCs found:
Invalid TOC: Name(1947768) Sysid(47768) Gen(154901) Modified(2020-01-31 03:56:05 IRST) Disk count(13/22)
Not enough TOCs of this generation to make quorum (60% needed).
1 disks were considered invalid TOC sources due to invalid TOC headers.
i have live data in this storage and cant used wipe sulotion
i was connect each 4 node mfg port and in whack mode reset node and used command setsysmgr -f tocgen but dosnt work and dont show anythig
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-04-2020 05:54 PM - last edited on 02-04-2020 08:32 PM by Parvez_Admin
02-04-2020 05:54 PM - last edited on 02-04-2020 08:32 PM by Parvez_Admin
Re: Table of contents (TOC) quorum not reached. 3par7400
Hello arashk0,
Firstly its not advisable to force a boot with an invalic TOC which may result in data loss.
Please check if the nodes are all online ( Check LED status on all nodes ) and if all the cages are online and power supplies are all OK.
If they are all confirmed good, you may need to power cycle the array.
Shutdown the system gracefully
Power off the disk cages ( do not power cycle the nodes/node cage )
Give it a few minutes before powering on disk enclosures.
Power on one disk enclosure at a time and allow it to come up fully. Ensure cage LEDs are all green.
Now, Use whack and reset nodes one after the other without much delay in between.
I'm an HPE Employee