3PAR StoreServ Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

replac node hp 3par 7200 cannot jion to cluster

amir_sh
Frequent Advisor

replac node hp 3par 7200 cannot jion to cluster

hi

 

i replace a node According to HP REPLACE NODE DOC  every thing ok else can not join to cluster.

 

error::::: code cage 0 interface card 0 failed (cpu firmware unknown) massage code: 00x02d00fa

 

pls help

 

 

 

9 REPLIES
Dennis Handly
Acclaimed Contributor

Re: replaced node HP 3PAR 7200 cannot join cluster

>cage 0 interface card 0 failed (cpu firmware unknown) massage code: 00x02d00fa

 

Is this on the replaced node?

Have you tried upgradecage?

What does "showcage -d" show?

amir_sh
Frequent Advisor

Re: replaced node HP 3PAR 7200 cannot join cluster

hi

 

No updates had been made.
 nod can not  be entered The cluster .
replacement nod.

 

on showcage -d  :

 

Hard drives that work with the controller node1 -  other contopller ok.

 

 

on Replaced nod show:

 

status :fix green

UId:off

fault :off

 

thanks

Dennis Handly
Acclaimed Contributor

Re: replaced node HP 3PAR 7200 cannot join cluster

So you're saying that "showcage -d" shows the normal output for all the cages and drives?

What did upgradecage show?

amir_sh
Frequent Advisor

Re: replaced node HP 3PAR 7200 cannot join cluster

on showcage -d:

replacement nod1 :there was not at list.and hard disks connect to only nod0.

 

any config need for join to cluster :rescue or ....

Of course, this command is entered

 

 

Or a specific point should be considered.

 

status LED on replacment nod is fix green , uid and fault is off.

 

 

NOT JOIN TO CLUSTER .

salla
Occasional Visitor

Re: replaced node HP 3PAR 7200 cannot join cluster

if I want to replace a faulty node with new one , it is necessary to clear all configuration of new one before installing to cage or no ? maybe there is a configuration on new node that prevent new node to join to cluster! how could I clear previous configuration of a node ?

Andrey_Kras
Occasional Visitor

Re: replaced node HP 3PAR 7200 cannot join cluster

I have the same trouble.

Have you a solution this ?

amir_sh
Frequent Advisor

Re: replaced node HP 3PAR 7200 cannot join cluster

hi

i can jion new node

Torsten.
Acclaimed Contributor

Re: replaced node HP 3PAR 7200 cannot join cluster

did you try a noderescue for the new node?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
SNPP
Occasional Contributor

Re: replac node hp 3par 7200 cannot jion to cluster

>>> i replace a node According to HP REPLACE NODE DOC every thing ok else can not join to cluster.
 

All nodes must be in the same network. Did you connect the node to the network before turning it on?