3Par v400. How do you remove manually added host WWNs?

[figwiggleman]

I manually added some WWNs for an HPUX host1 because they would not appear in the Available WWNs list in IMC. I then discovered a zoning issue and was able to get a second HPUX host2 WWNs to appear in the IMC without manually adding them. Then I removed host1 WWNs from the SAN switch zone config, yet they still appear in the IMC. How can I remove them?

Thanks,

Tim

[Sheldon Smith · Accepted solution]

See the CLI. Try

controlport nssync [–f] <N:S:P>...

[figwiggleman]

Well I had already gotten this answer from our support engineer this morning, but yes that command did it. I ran it on each front end port showing the "Ghost WWNs". Thank you Sheldon.