HPE 3PAR StoreServ Storage
1752815 Members
5804 Online
108789 Solutions
New Discussion

EVA to 3Par Online Import -- volume accessible though one peer port

 
David_Hickok
Occasional Advisor

EVA to 3Par Online Import -- volume accessible though one peer port

 

I'm working on doing an EVA to 3Par online import between an EVA 4400 and 3Par V400 using CommandView

10.3.6.150143.  I'm 95% certain I have the zoning correct; the tool passes all the pre-flight checks and only fails at the final migration screen with the following error:  "Volume <UUID" is only accessible through one peer port":

ImportError.jpg

I found a troubleshooting article that advised checking the targets on the 3Par as well as manually presenting the EVA LUN to the 3Par directly.  I did that and everything looks good in the command output.

HPN-3Par-3 cli% showtarget

Port  ----Node_WWN---- ----Port_WWN---- ------Description------

0:2:1 5001438004C5E180 5001438004C5E189 reported_as_scsi_target

0:2:2 5001438004C5E180 5001438004C5E188 reported_as_scsi_target

 

HPN-3Par-3 cli% showtarget -lun 5001438004C5E188

                                                                  ---Size(MB)---

Lun ----Node_WWN---- ------------Lun_WWN------------- Device_Type -VSize- -Rsvd- --MFR--- -State- -Vendor_Specific-

  0 5001438004C5E188                 5001438004C5E180 unknown           0     NA HP       --      NA

  1 5001438004C5E188 600508B4000987100000700000380000 disk        1024000     NA HP       --      NA

 

 

HPN-3Par-3 cli% showtarget -lun 5001438004C5E189

                                                                  ---Size(MB)---

Lun ----Node_WWN---- ------------Lun_WWN------------- Device_Type -VSize- -Rsvd- --MFR--- -State- -Vendor_Specific-

  0 5001438004C5E189                 5001438004C5E180 unknown           0     NA HP       --      NA

  1 5001438004C5E189 600508B4000987100000700000380000 disk        1024000     NA HP       --      NA

 

1 REPLY 1
Ashoka_R
Occasional Advisor

Re: EVA to 3Par Online Import -- volume accessible though one peer port

You are using the peer ports on destination from same node 0. The ports 0:2:1 & 0:2:2. This is not supported. You need to use the ports from adjacent node pairs for peer motion Example would be 0:2:1 & 1:2:2. Correct the zoning and you will be able to migrate the volumes.

I'm a HPE Employee