3PAR StoreServ Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

How to get CPG raid type from CLI in HPE 3PAR?

 
SOLVED
Go to solution
Highlighted
Occasional Contributor

How to get CPG raid type from CLI in HPE 3PAR?

Was testing out CPG configurations on our new 3PAR and am trying to get RAID configuration info from the CLI. I've already taken a look at this link here: https://community.hpe.com/t5/3PAR-StoreServ-Storage/How-to-get-HP-3PAR-CPG-Raid-Configuration-info-from-CLI/td-p/6872108
I can interpret "showcpg -sdg", where the argument after -t is the raid type, but not for the third CPG.

3par cli% showcpg -sdg
------(MiB)------
Id Name Warn Limit Grow Args
0 FC_r1 - - 32768 -ssz 2 -ha mag -t r1 -p -devtype FC
1 FC_r6 - - 32768 -ssz 6 -ha mag -t r6 -p -devtype FC
2 CPG_test 40960 81920 8192 -ha mag -ssz 3 -p -devtype FC -rpm 10

Are there any ways to interpret what RAID type that CPG is? Or are there any other commands I can run to check?

2 REPLIES 2
Highlighted
Solution

Re: How to get CPG raid type from CLI?

Reading the 3PAR Command Line Reference manual, the "createcpg" command has a default raid type. With 3PAR OS 3.3.1, the default is RAID6.

If you have created one or more volumes using CPG_test, there will be logical disks (LD) created against the CPG. Use the command "showld -cpg CPG_test" to see the characteristics of the LDs.


Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo

Highlighted
Occasional Contributor

Re: How to get CPG raid type from CLI?

That's perfect, thank you so much for the quick solution!