3par SS7200硬盘扩容

[sp_huang]

3par SS7200硬盘扩容

Step 1 Run a health check.

      Healthcheck

      showsys –d     ####核对设备序列号

Step 2 Put SP in maintenance mode.

Step 3 Install new licenses

      license注册时使用3par序列号

showlicense –raw    ####查看license信息

setlicense          #### 注册license 可以将license串号一起黏贴上去

showlicense        ####  确认添加license信息

Step 4 Install new drives to existing SFF enclosures

      硬盘前面板需要用6角螺丝刀锁紧

      Showpd

      showpd –i 

      showcage –d

Step 5 Admit HW

     Cli% admithw

Checking nodes...

Checking volumes...

Checking system LDs...

Checking ports...

Checking state of disks...

12 disks require firmware upgrades.

This will require approximately 10 minutes.

Enter y to proceed with this action, or n to skip it.

N

tarttask  admithw -ni 

showtask

Step 6 Put SP off from maintenance mode

Step 7 Run health check at the end