HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Array Performance and Data Protection
cancel
Showing results for 
Search instead for 
Did you mean: 

Dedublication on the CS-series

 
davidthor30
Occasional Contributor

Dedublication on the CS-series

When is dedublication planned for Nimblestorage on the CS-Series ?

1 REPLY
dnewby121
Occasional Visitor

Re: Dedublication on the CS-series

It's available now in 5.0.1.0  for CS3000 and CS5000 arrays only, but it has a restriction on flash to disk ratio.  No love for my poor little CS1000.  

You can enable deduplication for CS3000 and CS5000 arrays on a volume only if the corresponding storage pool has a Flash to Disk Ratio (FDR) of 4% or higher. To calculate the FDR, obtain the "Total array cache capacity (MiB)" and "Total array cache capacity (MiB)" values by using the pool --info pool_name HPE Nimble Storage CLI command: FDR = "Total array cache capacity (MiB)"/"Total array capacity (MiB)" * 100 If the array has sufficient capability for deduplication, the pool --info pool_name command will also show a value for Dedupe capacity (MiB).