HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Array Performance and Data Protection
cancel
Showing results for 
Search instead for 
Did you mean: 

Volume Performance Monitoring

 
SOLVED
Go to solution
Jacob_Wilde
Advisor

Volume Performance Monitoring

Anyone else run into this where trying to look at historical performance monitoring data and you get no activity? Not very helpful...

2 REPLIES
mgram128
Valued Contributor
Solution

Re: Volume Performance monitoring

Jacob, you should not get the "no activity" label on the charts unless indeed there were no IO going to that volume.   I would check the volume mapping from the array (target) to the host (initiator) to confirm that right volume is being referenced.   Also, I'd check the Infosight Portal to see if you are getting no IO reported there as well.

Jacob_Wilde
Advisor

Re: Volume Performance monitoring

It appears to be all volumes for this specified 24 hour period all report "no activity", so I don't think it's an issue with incorrect volume or mapping. I've opened a case with support, but I seem to recall running into this before and was wondering if anyone else has encountered this.