Array Setup and Networking
1748201 Members
3167 Online
108759 Solutions
New Discussion

Re: About Storage Controller P830i Question

 
Mesena
Occasional Contributor

About Storage Controller P830i Question

Hello everyone:
I only have one SSD hard disk, I made RAID0 for the SSD hard disk, but its IO speed is very slow and the write speed is only 8Mb/s When I copy files, the hard disk is brand new.

So, I want to pass the SSD hard disk directly in the SSA tool. When I try to change the 'RAID' mode to 'HBA' mode, the status of 'Exposed To OS' is 'NO', which prevents me from installing and entering the operating system.


my question:
1. How to have faster IO read and write speed in 'RAID0' mode?
How do I set 'Strip Size / Full Stripe Size' and 'Sectors / Track'?
(So that I can copy files faster)

2. How to enable 'Exposed To OS' in 'HBA' mode?
(So that I can install the operating system)

I haven't slept for two days, I need your help >_<
Thank you very much!


Server: HP DL580 Gen8
Storage Controller: P830i
Storage Controller Firmware: 2.04
SSA Tool Version: 2.65.7.0
SSD: Intel 535 SATA III 180G

1 REPLY 1
Torsten.
Acclaimed Contributor

Re: About Storage Controller P830i Question

The firmware is too old! Consider an update!

A RAID drive is hidden in HBA mode, so you need to delete the RAID drive first.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!