Array Setup and Networking

How many amps does a CS220 take or need?

SOLVED
Go to solution New Member

How many amps does a CS220 take or need?

Looking at the amp requirements or take from a CS220...

6 REPLIES 6 Valued Contributor

Re: How many amps does a CS220 take or need?

Hi Juan,

The 220 draws up to 500W so Power (in Watts) = volts x current (in Amps). In the UK that would be I (in amps) = P (in Watts) divided by V(volts). So 500/240 = 2.0833333 amps.

Regards,

Mark. Trusted Contributor
Solution

Re: How many amps does a CS220 take or need?

From the current Nimble Storage Hardware Guide:

• CS210: 450W

• CS200 series: 500W

• CS400 series: 550W

• ES series: 400W

• Steady state: 5A @ 120V

• Startup: 6A @ 120V

Caution: Startup current draw may exceed that 6A. Honored Contributor

Re: How many amps does a CS220 take or need?

Just for completeness

The CS700 is 650 watts

All-Flash shelf is 200 watts

Remember for your Amps - your voltage may vary based on which country your in  Valued Contributor

Re: How many amps does a CS220 take or need?

I was just using Ohms law. I appreciate there is usually an initial power on surge. P=V * I Valued Contributor

Re: How many amps does a CS220 take or need?

My background many years ago was in Radar and guidance systems so basic electricity and electronics are my Forte. Valued Contributor

Re: How many amps does a CS220 take or need?

No argumements from me but excepting the initial power on I believe my reply was a correct answer else Ohms law law is a pile of Pooh