HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Array Setup and Networking
cancel
Showing results for 
Search instead for 
Did you mean: 

Renaming an Array

 
SOLVED
Go to solution
jsprague124
Occasional Visitor

Renaming an Array

I've been asked to rename one of our arrays to make InfoSight a bit easier to read, etc.  Is there anything I need to be concerned about when doing so?  We currently are utilizing the array for iSCSI storage to a vsphere 5.5 cluster.  Obviously, I don't want to interrupt that access.  The array in question is a CS240G-X2

Thanks

2 REPLIES
tmoore106
Trusted Contributor

Re: Renaming an array

No worries. It will show up as a "new array" in Infosight with all the trending beginning right when you make the change. There is nothing involving connectivity with the hosts that is tied to the array name.

pfrisoli27
Valued Contributor
Solution

Re: Renaming an array

Hi Joel,

You can modify the name of the array either via the GUI or CLI. I would certainly pick a maintenance window to do this as I do with all changes, but there should be no impact as the presentation of Nimble is at the group level not array level. I would suggest upgrading to the latest firmware release prior to making the change as a best practice. I hope this helps.