Aruba & ProVision-based
cancel
Showing results for 
Search instead for 
Did you mean: 

2610-48 PoE will not power up a Cisco 1231 AP

 
RichD
Occasional Contributor

2610-48 PoE will not power up a Cisco 1231 AP

Recently added a J9089A and moved the patch cable for a Cisco 1231 LAP to the 2610...AP would not power up. When patched back to the 2910, worked perfectly (same patch, interconnect,...). The AP is only single radio and should only draw 6W. I plugged an IP phone into the 2610 and it powers up and works fine. There are no other devices powered up on the 2610 since it is a new area of the building. The AP is the only device that is pulling power from from the switch. Updated firmware to the latest, still no luck.

3 REPLIES 3
Highlighted
RichD
Occasional Contributor

Re: 2610-48 PoE will not power up a Cisco 1231 AP

Received an answer back from my reseller that the 48 port does not support the Cisco pre-standard PoE requirement. Of course I asked why the 24 port 2610 did...no response.

paulgear
Esteemed Contributor

Re: 2610-48 PoE will not power up a Cisco 1231 AP

Different ProCurve models seem to have different levels of pre-standard PoE support. I have NEC IP phones that only work on 2600-8-PwR switches, but not on 2626s or 2650s that were bought at exactly the same time and have otherwise-identical capabilities.
Regards,
Paul
paulgear
Esteemed Contributor

Re: 2610-48 PoE will not power up a Cisco 1231 AP