Aruba & ProVision-based
1748108 Members
5239 Online
108758 Solutions
New Discussion юеВ

Re: Alternative Command for 'broadcast-limit' in hpe 2620 switch

 
MOHD_HUB
Occasional Visitor

Alternative Command for 'broadcast-limit' in hpe 2620 switch

I want to configure new switch hpe 2620 with a configuration with :

interface 16
broadcast-limit 7

but the switch not accept '' broadcast-litmit'' command, there is only rate-limit but only with inbound, and what I know that broadcast-litmit is for outbound.

3 REPLIES 3
akg7
HPE Pro

Re: Alternative Command for 'broadcast-limit' in hpe 2620 switch

Hi,

'broadcast-limit' command is deprecated.

'rate-limit bcasr in' only rate limit both traffic.

Please refer below links:

https://techhub.hpe.com/eginfolib/networking/docs/switches/K-KA-KB/15-18/5998-8160_ssw_mcg/content/ch05.html

https://community.arubanetworks.com/t5/Wired-Intelligent-Edge-Campus/Limiting-Broadcast-Traffic/ta-p/436298

or open a case with support so they can help you further.

Thanks!

Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the companyAccept or Kudo
MOHD_HUB
Occasional Visitor

Re: Alternative Command for 'broadcast-limit' in hpe 2620 switch

Thank you akg7 for your help, 'rate-limit bcasr in' is for inbound as I read.

akg7
HPE Pro

Re: Alternative Command for 'broadcast-limit' in hpe 2620 switch

Hi,

I haven't found anyother command, could you please log a case with support.

Thanks!

Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the companyAccept or Kudo