Aruba 2920 triple Stack Trunk Status

[AbeAbe]

Too bad....

perhaps... not as good but either helpful:

sh int brief | incl Trk5
C3-Trk5 1000SX | No Yes Up 1000FDx NA off 0
C4-Trk5 1000SX | No Yes Up 1000FDx NA off 0
C5-Trk5 1000SX | No Yes Up 1000FDx NA off 0
C6-Trk5 1000SX | No Yes Up 1000FDx NA off 0

but take care it's Trk5 not trk5

hth

Alex

[nettec]

Hey Alex

Unfortunately still no luck... The command only shows:

sw-stack01# sh int brief | incl trk6
sw-stack01#

It actually does just nothing...

Thx, Cedric

[AbeAbe · Accepted solution]

ok...

try

sh int brief | incl Trk6

it's important that it is Trk6 not trk6!

example from a 2920 stack:

sw21-2920-3# sh int brief | incl Trk26
1/47-Trk26 1000SX | No Yes Up 1000FDx NA off 0
3/47-Trk26 1000SX | No Yes Up 1000FDx NA off 0

hth

[parnassus]

If it's case sensitive...it's case sensitive! ;-).

[nettec]

Good Morning

Yeah I actually knew that, but forgot case sensitivity anyway... :)

That did the trick:

sw-stack01# sh int brief | incl Trk6
1/15-Trk6 100/1000T | No Yes Up 1000FDx MDI off 0
1/16-Trk6 100/1000T | No Yes Up 1000FDx MDIX off 0
1/A1-Trk60 SFP+SR | No Yes Up 10GigFD NA off 0
2/14-Trk6 100/1000T | No Yes Up 1000FDx MDI off 0
2/15-Trk6 100/1000T | No Yes Up 1000FDx MDI off 0
2/16-Trk6 100/1000T | No Yes Up 1000FDx MDI off 0
2/A1-Trk60 SFP+SR | No Yes Up 10GigFD NA off 0
3/14-Trk6 100/1000T | No Yes Up 1000FDx MDI off 0
3/15-Trk6 100/1000T | No Yes Up 1000FDx MDIX off 0
3/16-Trk6 100/1000T | No Yes Up 1000FDx MDI off 0
3/A1-Trk60 SFP+SR | No Yes Up 10GigFD NA off 0

I think it shows Trk60 too because it also begins with a 6, but I can live with that. This was exactly what I was searching for.

Thank you very much you two

Best regards, Cedric