Aruba & ProVision-based

Aruba wifi vlan

 
NICOLASOLIUY
Occasional Contributor

Aruba wifi vlan

Hello how are you? I need help with a Hpe 1950 JG962A switch and Aruba 7010 and Ap 515 solution. I have 2 vlan one for employees another for guests 10 and 20. The Aruba 7010 controller is connected to port 1 of the hpe 1950 and has the 2 vlan configured and works correctly. I have doubts about the APs since they are connected in the sw hpe 1950 and I do not know how to configure them so that the ap take dhcp from the vlan 10 that the client server gives it and that in turn the guest wifi works in the vlan 20 I don't know how to configure the hpe 1950 ports for the ap take dhcp from vlan 10. Can you help me? How would the ports and vlan of the hpe 1950 be configured?
2 REPLIES 2
akg7
HPE Pro

Re: Aruba wifi vlan

Hello @NICOLASOLIUY,

I believe you can refer below link for AP-515 DHCP cpnfiguration:

https://www.arubanetworks.com/techdocs/Instant_83_WebHelp/Content/Instant_UG/DHCP_conf/DHCPConfiguration.htm

Thanks!

Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the companyAccept or Kudo
-Alex-
HPE Pro

Re: Aruba wifi vlan

Hello NICOLASOLIUY,

Please try the following steps in the web gui of 1950 switch (in the example the DHCP server is 10.1.11 please change it accordingly):

Perform the following tasks:
− Enable the DHCP service.
− Configure VLAN-interface 10 to operate in DHCP relay agent mode.
− Specify the IP address of the DHCP server as 10.1.1.1.
Access the advanced settings page to perform the following tasks:
− Enable the DHCP relay agent to record client information.
− Enable the relay agent to fresh relay entries periodically.
− Set the refresh internal to 100 seconds.

If you are setting it up using command line you may use the following link to see how it is configured in CLI:

https://support.hpe.com/hpesc/public/docDisplay?docId=c03477763&docLocale=en_US 

Hope this helps!

I am an HPE Employee

Accept or Kudo