HPE Community
Aruba & ProVision-based
1751687 Members
5470 Online
108781 Solutions
New Discussion

CCTV cameras working only in Unicast not in Multicast ??

 
Shamim Kamarudeen
Occasional Contributor

‎05-18-2010 02:52 AM - last edited on ‎03-03-2014 06:02 PM by

‎05-18-2010 02:52 AM - last edited on ‎03-03-2014 06:02 PM by

CCTV cameras working only in Unicast not in Multicast ??

hi,
After i create new different vlans in the network,there were more than 500 bosch cameras which are working only in unicast and not in multicast,i have enable the ip igmp and flow control in all the switches(2810G) in CCTV vlan where the cameras are connected.
Core & Distribution switches as 5406zl and 2810-48G & 281024G as edge switches.before this was flat network(everything is in only one vlan(vlan1)) and the multicasting was working fine.now the CCTV cameras and servers are in different vlans.
Expecting your valid reply
Thanks..

 

 

P.S. This thread has been moevd from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. - Hp Forum Moderator

0 Kudos
1 REPLY 1
dave_tucker
Advisor

‎05-26-2010 10:28 AM

‎05-26-2010 10:28 AM

Re: CCTV cameras working only in Unicast not in Multicast ??

Hi,

The reason that multicast is not working between VLANs is that you have not configured multicast routing.

You will need to enable PIM in either sparse or dense mode using the following guide:

http://cdn.procurve.com/training/Manuals/3500-5400-6200-6600-8200-MRG-Mar10-K_14_52.pdf

Hope this helps.

Dave
Technical Marketing Engineer @ HP and self-proclaimed SDN ninja. Words are my own...
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.