- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- Cant add ip-helper address
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-16-2018 01:11 PM
10-16-2018 01:11 PM
Cant add ip-helper address
When attempting to add an ip helper-address to a vlan on a 5406zl I receive the error "unable to add record to table" this only occurs on 1 vlan. Any advice would be greatly appreciated.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-30-2018 06:15 PM
10-30-2018 06:15 PM
Re: Cant add ip-helper address
Please refer to this link https://support.hpe.com/hpsc/doc/public/display?sp4ts.oid=1009060842&docLocale=en_US&docId=emr_na-a00050242en_us (Start from page192), these are the details for how to configure ip-helper.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-09-2018 07:21 AM - edited 11-09-2018 07:26 AM
11-09-2018 07:21 AM - edited 11-09-2018 07:26 AM
Re: Cant add ip-helper address
This is probably bug in firmware. I recently have similar issue with ip class ipv4 command. For me the only right solution was reload switch or restart primary and secondary management module one by one (only if you have dual mgmt card).
You can do this in following manner:
- Reboot the standby module using the
boot standaby
(and wait a few minutes)
- Confirm that the standby module is now running
show redundancy
- Switchover from the active to the standby module – this caused a few seconds of downtime in my environment (in L3 routing particular):
redundancy switchover
- Once the failover is complete the previously active module will now can be reload too and after this you can revert back to mgmt1 module acting as active (remember about downtime)