- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- Re: Changing speed on ProCurve J9087A Switch 2610-...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-12-2019 03:00 AM
09-12-2019 03:00 AM
Hi,
I want to change the speed of a port of ProCurve J9087A Switch 2610-24-PWR to support 1000mo
Although when I run this command :
(eth-3)# speed 1000-full
I got this error "Value 1000-full is not applicable to port 3"
The port is (10/100TX) and the mode is MDIX
Any idea?
Thank you.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-12-2019 12:40 PM
09-12-2019 12:40 PM
SolutionImpossible to change speed port to 1000 Mbps (1 Gbps) on Port 3 considering all 24 ports are 10/100 Mbps at maximum (Ethernet/Fast Ethernet not Gigabit Ethernet as you want)...your Switch is a Fast Ethernet Switch with just some ports (25-28) that support Gigabit Ethernet...thus, at best, you can use one of the four Combo ports (ports 25 / 26 are Copper RJ45 Gigabit Ethernet OR ports 27 / 28 are Mini-GBIC for SFP - Fast Ethernet or Gigabit Ethernet - Transceivers <- pay attention that if you use port 25 you can't use prot 27 and viceversa, the same is true for pair 26/28). Definitely port 3 is out-of-question for Gigabit Ethernet, it runs only at 10/100 Mbps speeds.
I'm not an HPE Employee