Configuring routing between two vlans

[IgorUshakov]

I have HP ProCurve 2910al-48G

And 2 Vlans:

Vlan10

ip 192.168.0.240/24

untagged 5-6

port 5 down

port 6 up

Vlan20

ip 172.16.10.240/24

untagged 20-21

port 20 down

port 21 up

Can I set up routing between them only by means of a switch, and how?

[Ian Vaughan]

Howdy,

If you wish to enable the Layer 3 features of the switch to enable inter-valn routing, change to configuration mode and issue: 

# ip routing

at the command prompt

You will probably need to configure a default route (ip route 0.0.0.0 0.0.0.0 <gateway IP> ) rather than a default gateway in this scenario.  

many thanks

Ian