HPE Community
Aruba & ProVision-based
1752758 Members
4956 Online
108789 Solutions
New Discussion

Disable and block IPv6 on Procurve 2510g and 2520g

 
PaulPool89
Occasional Contributor

‎03-27-2018 05:55 AM - edited ‎03-27-2018 06:01 AM

‎03-27-2018 05:55 AM - edited ‎03-27-2018 06:01 AM

Disable and block IPv6 on Procurve 2510g and 2520g

Hello,

I am looking for the commands to disable and block IPv6 traffic on Procurve 2510g and 2520g.

I am able to run the command "show ipv6" and it shows IPv6 as disabled on the 2520's, however the command does not work on the 2510's. I'm assuming ther 2510's are still forwarding traffic. I have not found much searching this forum and google for the direct commands to just shut off IPv6 and stop forwarding its traffic on the enitre switch.

Thank you.

0 Kudos
1 REPLY 1
PaulPool89
Occasional Contributor

‎03-28-2018 07:15 AM

‎03-28-2018 07:15 AM

Re: Disable and block IPv6 on Procurve 2510g and 2520g

Well over 100 views in less than 24 hours... Does anyone have the commands to block all IPv6 traffic and forwarding on these older procurves?

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.