Aruba & ProVision-based
1752777 Members
6423 Online
108789 Solutions
New Discussion

Re: Error Log after firmware update

 
Cüneyt
Occasional Contributor

Error Log after firmware update

Hi People,

we have just upgraded the firmware of a 8212 zl2 Modular Switch. After the upgrade we get the error message below. The configuration is also shown. The switch works fine but we didn't understand what that error log means? Could you please take a look and if you understand it, could you please help us? 

after upgrading to firmware K.15.18.0017 we get the following error: 

W 09/22/17 10:24:08 02581 ip: AM1: IPv4: Duplicate IPv4 address 10.34.160.1 is

            detected on VLAN 3 with a MAC address of 2c4138-cdca00 (5 times in

            60 seconds)

W 09/22/17 10:24:08 02581 ip: AM1: IPv4: Duplicate IPv4 address 10.34.136.1 is

            detected on VLAN 100 with a MAC address of 2c4138-cdca00 (16 times

            in 60 seconds) 

Configuration is as below:

vlan 3

   name "AD_Client_VL3"

   tagged A1-A8,B1-B7,D1-D8,E21-E24,F1-F2,F4,F21-F24,G20,J1-J24,Trk1

   untagged F20,G21

   ip helper-address 10.34.128.200

   ip address 10.34.136.1 255.255.252.0

   exit

 

vlan 100

   name "AD_Client2"

   tagged A1-A8,B1-B7,D1-D8,E21-E24,F1-F2,F4,F17,F21-F24,G1-G2,G11,J20,J23-J24

   ip helper-address 10.34.128.200

   ip address 10.34.160.1 255.255.252.0

   exit

4 REPLIES 4
Crazy_Diamond
Occasional Advisor

Re: Error Log after firmware update

Did you try finding out what device has mac-address 2c4138-cdca00 ?

Cüneyt
Occasional Contributor

Re: Error Log after firmware update

The MAC Address belongs to the 8212 zl2 Chassis itself. 

parnassus
Honored Contributor

Re: Error Log after firmware update

What's about Port Trunking configurations? could you provide us some info about how many they are and how they were configured (Static versus Dynamic)?

Commands show trunk and show lacp should shed some light...


I'm not an HPE Employee
Kudos and Accepted Solution banner
Cüneyt
Occasional Contributor

Re: Error Log after firmware update

Hello Parnassus,

according to your post, I forward it to our tech guys. The answer is as below.

ULUS_OMURGA# sh trunks 

Load Balancing Method:  L3-based (default) 

  Port | Name                             Type       | Group  Type

  ---- + -------------------------------- ---------- + ------ --------

  F11  |                                  100/1000T  | Trk1   LACP

  F13  |                                  100/1000T  | Trk1   LACP