HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Aruba & ProVision-based
cancel
Showing results for 
Search instead for 
Did you mean: 

HP 2530 48 POE+ J9772A Not accepting 255.255.254.0 for netmask

 
osiadm
Occasional Visitor

HP 2530 48 POE+ J9772A Not accepting 255.255.254.0 for netmask

Hi,

I'm configuring my network devices to use a /23 netmask. All of the devices have accepted the netmask without problems, Cisco, Ubiquiti, Grandstream, Fortinet, etc.

I have a HP 2530 48 POE+ (J9772A) that is not accepting that netmask. It was running an old firmware version and it was upgraded to the latest firmware version. Now it says that it is an Aruba. The IP address and netmask is configured for vlan1. It doesn't matter if it is via CLI or cosole the netmask is not accepted. The netmask have to be entered with dotted notation (255.255.254.0) becasue is not accepting CIDR (/23).

Please advice.

1 REPLY
Vince-Whirlwind
Honored Contributor

Re: HP 2530 48 POE+ J9772A Not accepting 255.255.254.0 for netmask

What does a show ip int all tell you?