Aruba & ProVision-based
cancel
Showing results for 
Search instead for 
Did you mean: 

HP 2620 Switch

 
lecarbajalp
Occasional Contributor

HP 2620 Switch

Hello i configured a sw 2620 as an acces switch I defined 1 vlan in order to connect phones there, i already integrate with my Cisco Switch 3750X, my only issue with the HP is that i can not ping to the VLAN IP even its connected some equipments to the switch, i attached the configuration.

 

vinterface 25
   speed-duplex 100-full
exit
interface 26
   speed-duplex 100-full
exit
interface 28
   speed-duplex 1000-full
exit
vlan 1
   name "DEFAULT_VLAN"
   untagged 1-28
   ip address dhcp-bootp
   exit
vlan 6
   name "VLAN6"
   ip address 10.10.4.10 255.255.255.0
   tagged 23
   exit
snmp-server community "public" unrestricted
spanning-tree priority 0 

 

The spanning tree is not enable because i will use this HP connected like daisy chain,

The idea to reach the IP is to monitor the equipment by snmp

I can not even reach the HP by ping even i configured the port in the cisco like access port.

Thank you.

 

 

P.S. This thread has been moevd from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. - Hp Forum Moderator

1 REPLY 1
Pourl
Frequent Advisor

Re: HP 2620 Switch

Hi, is port 23 on hp switch the uplink to the cisco switch?

Is the cisco switch uplink configured as trunk and allows all vlan or at least vlan 1 and 6?

routing and vlan 6 also have to be configured on cisco switch.

Furthermore the hp Switch need a default gateway. if you ping vlan 6 ip from a client in vlan 1 you won't be able to reach the switch.

i would say vlan 6 is your mgmt vlan, so vlan 1 doesnt need a (dhcp-)ip....

 

Pourl