Hi,
I`m fairly new to networking and VLANs but i`ve been tasked with setting up a new network for our business. At the moment i just have a router and an unmanaged switch and everything plugs into it.
I now have a cisco SA520 and a procurve 2650 which i would like to set up with VLANs for pc's, phones and guest wifi.
I`ve set up the following on the cisco SA520 router
- VLAN 1 (Default VLAN): 10.15.0.1 255.255.255.0
- VLAN 10 (DATA): 10.15.1.1 255.255.255.0
- VLAN 20 (VOICE): 10.15.2.1 255.255.255.0
- VLAN 30 (GUEST): 10.15.3.1 255.255.255.0
- port 1: Trunk VLANs 1,10,20,30
Port 1 of the cisco router plugs into port 49 of the procurve and port 50 was to go to another switch
On the Procurve 2650 i have set the following;
vlan 1
name "DEFAULT_VLAN"
untagged 31-40
ip address 10.15.0.200 255.255.255.0
ip helper-address 10.15.0.1
tagged 49-50
no untagged 1-30,41-48
exit
vlan 10
name "DATA"
untagged 1-20
ip address 10.15.1.2 255.255.255.0
ip helper-address 10.15.1.200
tagged 49-50
exit
vlan 20
name "VOICE"
untagged 21-30
ip address 10.15.2.2 255.255.255.0
ip helper-address 10.15.2.200
tagged 49-50
voice
exit
vlan 30
name "GUEST"
untagged 41-48
ip address 10.15.3.2 255.255.255.0
ip helper-address 10.15.3.200
tagged 49-50
exit
Is this set up correctly and should i see a different subnet ip address at the different VLANs when i plug my laptop in?
Any help most appreciated.
Thanks
James
