HP Procurve 2910al Stacking?

[vieirar]

I was wondering if the HP 2910al-24G Switch (J9145A) had the ability to Stack and present as a single switch? I would like to stack 2 of my 2910's using Ports 23 and 24 (LACPed), is this possible?

[parnassus · Accepted solution]

(Front/Backplane) Stacking to form a virtual logical switch is not supported on that switch series.
You can deploy Ports Trunking (LACP) between them for sure, that's uplinking via Ports Trunking, not stacking.

[vieirar]

Thanks for the confimation as I felt that was the case as I couldn't find the Stacking Command. I also ensure I had the latest firmware, just wasn't sure if I was missing something. Too bad was hoping I could LACP Stack them and use them differently, well I still have a use for them. Thanks for confirming the info.  I do have some 2920's with stacking modules stacked in a ring topology was  hoping these could do something similar.