Aruba & ProVision-based
cancel
Showing results for 
Search instead for 
Did you mean: 

HP Procurve 2910al Stacking?

 
SOLVED
Go to solution
vieirar
Occasional Advisor

HP Procurve 2910al Stacking?

I was wondering if the HP 2910al-24G Switch (J9145A) had the ability to Stack and present as a single switch? I would like to stack 2 of my 2910's using Ports 23 and 24 (LACPed), is this possible?

2 REPLIES 2
parnassus
Honored Contributor
Solution

Re: HP Procurve 2910al Stacking?

(Front/Backplane) Stacking to form a virtual logical switch is not supported on that switch series.
You can deploy Ports Trunking (LACP) between them for sure, that's uplinking via Ports Trunking, not stacking.
vieirar
Occasional Advisor

Re: HP Procurve 2910al Stacking?

Thanks for the confimation as I felt that was the case as I couldn't find the Stacking Command. I also ensure I had the latest firmware, just wasn't sure if I was missing something. Too bad was hoping I could LACP Stack them and use them differently, well I still have a use for them. Thanks for confirming the info.  I do have some 2920's with stacking modules stacked in a ring topology was  hoping these could do something similar.