Aruba & ProVision-based
cancel
Showing results for 
Search instead for 
Did you mean: 

HP Procurve 5412zl

 
NManager
Occasional Contributor

HP Procurve 5412zl

Hello,

I wonder if someone can help me please.

I have HP Procurve 5412zl network switch on my network and would like to setup some WAN routing. The firmware version on it is K.15.17.0007.

To get this configured, I have been requested to assign an IP address 192.168.101.2 to one of the Ports on my 5412zl switch, so that the MPLS equipment can be plugged into this port. Furthermore, I have been asked to setup some static routes on the switch in order to faciltitate that WAN connection via the MPLS equipment.

To this end, I have logged into the switch (via Telnet) to try to assign an IP Address to a single port, but I keep getting the error message 'Invalid Input' when I type either Interface J1 192.168.98.2 255.255.255.252 or Interface J1 ip address 192.168.98.2 255.255.255.252 at the config# prompt.

Therefore, I am not sure if this switch allows the assignment of an IP address to a single port, though it is a Layer 3 switch. Perhaps, I will have to create a VLAN then add an IP address to the VLAN then assign the single to port to it?

Please help, thank you in advance.

1 REPLY 1
rajkumar787
HPE Pro

Re: HP Procurve 5412zl

Hi,

Yes, you need to create a VLAN, assing the ip address to the VLAN, and untagg/tag that port.

You cannot assign an IP Address to any port on Procurve switch

 

Regards

Raj

Thank You!
I am an HPE Employee

Accept or Kudo