Aruba & ProVision-based

Re: HP Procurve qos/cos/DSCP Markings etc

 
vishal_123
Occasional Contributor

HP Procurve qos/cos/DSCP Markings etc

Hi

 

I have experience of bespoke qos marking configs on cisco cpe and on core Juniper PE routers but am new to HP procurve cli.

 

I am looking for a way to workout how much bandwidth is being seen per cos queue. The example HP L3 switch I have i can see the following defined.

 

-qos dscp-map <values>

-entry to accept tcp/udp traffic from that dscp value

-the dscp value assigned to a specific i.p address

 

Thanks.

 

 

3 REPLIES 3
LorenzoCastro
Frequent Advisor

Re: HP Procurve qos/cos/DSCP Markings etc

Hello, you would use the following command to view the COS-Queue assignments on this on an e series switch.

 

show qos queue-config

 

and you would use the following command to view bandwidth/queue assignment per port or for all ports.

 

show bandwidth output

 

Thanks,

 

Lorenzo

 

 

vishal_123
Occasional Contributor

Re: HP Procurve qos/cos/DSCP Markings etc

pretty basic stuff. The information only gives a percentage. is there no way to check how many packets are being marked/queued/dropped/bandwidth?

 

 

LorenzoCastro
Frequent Advisor

Re: HP Procurve qos/cos/DSCP Markings etc

Yep, it's GMB per queue.  You would have to enable qos watch-queue on the interface you want to monitor.  As of ver 15.04.000015 it was limited to 1 interface being monitored.  Also, in this version it only shows drops per queue, but does not show marked, dropped, queued, etc, like Catalyst switches.  I know the A series switches do show most of these stats similar to Cisco switches. Hopefully in later versions this has been enhanced on the E series.  You should give the command references a check.