Aruba & ProVision-based

HP TOPTOOL and ARP CACHE

 
SOLVED
Go to solution
Largeau
Occasional Contributor

HP TOPTOOL and ARP CACHE


How is it possible to get the arp cache of a procurve 4000 to find a specific IP adddress matching a MAC address with HP TOPTOOLS ???
4 REPLIES 4
Ron Kinner
Honored Contributor
Solution

Re: HP TOPTOOL and ARP CACHE

I've never used Toptools but the manual says you can get IP and MAC info from the Node Port Table. Devices/Device Types/Networking Types Then right click on Networking Types and selecting Node Port Table.

See Page 6-7 in the TopTools User manual

http://www.hp.com/rnd/support/manuals/toptools_hubs_switches.htm

Ron
Largeau
Occasional Contributor

Re: HP TOPTOOL and ARP CACHE

Thx for your answer but it's ok for us only vhen a port is connected to another HP Procurve but it's bad when the port is connected to an end node workstation.

Maybe it's because of our config.


Thanks again.


Jean-Luc Largeau
Ron Kinner
Honored Contributor

Re: HP TOPTOOL and ARP CACHE

Sounds like you do not have Discovery turned on. See Chapter 4 on Discovery. You may have to tell it about the subnetworks but it sounds like it should find all of the hosts on your network. It may take a while. Make sure you have Ping Discovery checked. (Fig 4-3)


Ron
Largeau
Occasional Contributor

Re: HP TOPTOOL and ARP CACHE

Thanks,

It's ok now !