- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- Re: I have to work on HP ProCurve 3500yl J8693A PO...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-30-2018 04:08 PM
04-30-2018 04:08 PM
I have to work on HP ProCurve 3500yl J8693A POE switch but it is showing a fault
Hi All,
I have given a switch HP Procurve 3500yl J8693A switch and after self test it shows a fault: Fault Led blinking.
But for this fault there is no solution given in Guide and Installtion.
Also when I connect the switch through console port to my laptop the command line is blank.
That means it gets connected but the cmd is blank.
Thanks all in advance.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-30-2018 10:33 PM
04-30-2018 10:33 PM
Re: I have to work on HP ProCurve 3500yl J8693A POE switch but it is showing a fault
@Sonya26 wrote: Also when I connect the switch through console port to my laptop the command line is blank.
Are you sure your serial console's settings (laptop side) are those expected (9600 baud, 8 data bits, No Parity, 1 stop bit and flow control set to Xon/Xoff)? if so - and no console appears - it's totally possible you're dealing with a Switch Hardware failure...
I'm not an HPE Employee