Aruba & ProVision-based
cancel
Showing results for 
Search instead for 
Did you mean: 

I have to work on HP ProCurve 3500yl J8693A POE switch but it is showing a fault

 
Sonya26
Occasional Visitor

I have to work on HP ProCurve 3500yl J8693A POE switch but it is showing a fault

Hi  All,

I have given a switch HP Procurve 3500yl J8693A switch and after self test it shows a fault: Fault Led blinking.

But for this fault there is no solution given in Guide and Installtion.

Also when I connect the switch through console port to my laptop the command line is blank.

That means it gets connected but the  cmd is blank.

 

 

Thanks all in advance.

1 REPLY 1
parnassus
Honored Contributor

Re: I have to work on HP ProCurve 3500yl J8693A POE switch but it is showing a fault


@Sonya26 wrote: Also when I connect the switch through console port to my laptop the command line is blank.

Are you sure your serial console's settings (laptop side) are those expected (9600 baud, 8 data bits, No Parity, 1 stop bit and flow control set to Xon/Xoff)? if so - and no console appears - it's totally possible you're dealing with a Switch Hardware failure...