- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- J9729A port going offine with Cisco APs attached
-
- Forums
-
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
- HPE Blog, Austria, Germany & Switzerland
- Blog HPE, France
- HPE Blog, Italy
- HPE Blog, Japan
- HPE Blog, Middle East
- HPE Blog, Russia
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
-
Blogs
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Blog, Latin America
- HPE Blog, Middle East
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
-
Information
- Community
- Welcome
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Tips and Tricks
- Resources
- Announcements
- Email us
- Feedback
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Aruba Airheads Community
- Enterprise.nxt
- HPE Dev Community
- Cloud28+ Community
- Marketplace
-
Forums
-
Blogs
-
Information
-
English
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
10-29-2019 10:04 AM
10-29-2019 10:04 AM
J9729A port going offine with Cisco APs attached
I have a procurve J9729A that has about five Cisco Air-Lap1142n APs connected. When I had to replace a couple of them they will stay up for about a couple of days and then go down for no apparent reason. When I check the switch logs I can track when the port goes offline. Link indicator shows no link and the AP is stil powered. Cabling is verified and good. Is there a way to force a port to stay on-line? I also checked POE settings and the switch is only using half it's 370 watts.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
11-02-2019 03:19 AM
11-02-2019 03:19 AM
Re: J9729A port going offine with Cisco APs attached
Hi!
Are you able to post outputs of
show power-over-ethernet <port-id or port-ids-range or port-ids-list>
CLI command?
Which software version is running on your Aruba 2920 Switch?
The Cisco Aironet 1140 Series supports IEEE 802.3af standard so it shouldn't be an issue about PoE if it is properly configured Switch side (thus the question: how it is actually configured switch side?).
I'm not an HPE Employee

Hewlett Packard Enterprise International
- Communities
- HPE Blogs and Forum
© Copyright 2021 Hewlett Packard Enterprise Development LP